IEI Technology tKINO-BW Series, User Manual, Page: 80 / 143

tKINO-BW SBC
Page 66
Figure 4-22: LVDS Voltage Select Jumper Location
4.7.6 mSATA and SATA2 Select Jumper
CN Label:
J_MS1
CN Type:
2-pin header, p=2.54 mm
CN Location:
See Figure 4-23
CN Settings:
See Table 4-5
Use the mSATA and SATA2 select jumper to set the priority of MSATA1 and SATA2
connectors since the MSATA1 slot is co-lay with the SATA2 connector. The mSATA and
SATA2 select jumper settings are shown in Table 4-5 .
Setting Description
Open
MSATA1 as the priority (Default)
(SATA2 will be disabled if an mSATA module is
installed in the MSATA1 slot.)
Short MSATA1 is enabled and SATA2 is disabled.
Table 4-5: mSATA and SATA2 Select Jumper Settings
The location of the mSATA and SATA2 select jumper is shown in Figure 4-23 below.