IEI Technology SPCIE-3600AM2, User Manual

Page: 54 / 215

SPCIE-3600AM2 PICMG 1.3 CPU Card
Page 34
3.1 Anti-static Precautions
WARNING:
Failure to take ESD precautions during the installation of the
SPCIE-3600AM2 may result in permanent damage to the
SPCIE-3600AM2 and severe injury to the user.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the SPCIE-3600AM2. Dry climates are especially susceptible to ESD. It is
therefore critical that whenever the SPCIE-3600AM2, or any other electrical component is
handled, the following anti-static precautions are strictly adhered to.
Wear an anti-static wristband : - Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.
Self-grounding :- Before handling the board touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.
Use an anti-static pad : When configuring the SPCIE-3600AM2, place it on
an antic-static pad. This reduces the possibility of ESD damaging the
SPCIE-3600AM2.
Only handle the edges of the PCB :-: When handling the PCB, hold the PCB
by the edges.
3.2 Unpacking
3.2.1 Unpacking Precautions
When the SPCIE-3600AM2 is unpacked, please do the following:
Follow the anti-static precautions outlined in Section 3.1 .
Make sure the packing box is facing upwards so the SPCIE-3600AM2 does
not fall out of the box.
Make sure all the components shown in Section 3.3 are present.