IEI Technology PUZZLE-5030, User Manual

Page: 31 / 119

PUZZLE-5030
Page 31
A CPU heatsink must be installed in the PUZZLE-5030-R after the CPU installation. The
CPU heatsink can be bought from IEI. To install the heatsink, follow the instructions below.
Step 1: A heatsink bracket is pre-installed on the rear of the motherboard
Step 2: Properly orient the CPU heatsink . The CPU heatsink must be oriented as
shown in Figure 3-7 so that thermal convection currents can carry the heat
away from the heatsink.
Step 3: Place the CPU heatsink onto the CPU . Push down the heatsink with some
pressure to secure the heatsink with the support bracket.
Step 4: Tighten the screws . Use a screwdriver to tighten the four screws. In a
diagonal pattern, tighten each screw a few turns then move to the next one,
until they are all secured. Do not overtighten the screws.
Figure 3-7: CPU Heatsink Installation
3.5 HDD Installation
The PUZZLE-5030 allows installation of two 2.5" SATA HDD/SSD. To install HDDs into the
system, please follow the steps below.
Step 1: Remove the top cover from the PUZZLE-5030. Please follow the instruction
described in Section 3.2 .