IEI Technology PPC-37xxA-N26, User Manual

Page: 73 / 203

PPC-37xxA-N26 Panel PC
Page 57
To access the panel PC internal components, the back cover must be removed. To
remove the back cover, please refer to
Section
8
3.5
for back cover removal instructions.
4.4 SO-DIMM Replacement
Please read the warnings at the beginning of the previous section before attempting to
access any PPC-37xxA-N26 internal components.
To install/replace the SO-DIMM modules, please follow the steps below.
Step 1:
Remove the back cover (
Section
8
3.5
).
Step 2:
Follow
Steps 2 ~ 4
in
Section 3.7
to release the motherboard from the panel
PC.
Step 3:
Locate the SO-DIMM module on the solder side of the motherboard.
Figure 4-1: SO-DIMM Module Location
Step 4:
Release the SO-DIMM module by pulling both the spring retainer clips outward
from the socket.
Step 5:
Grasp the SO-DIMM module by the edges and carefully pull it out of the socket.
Step 6:
Install the new SO-DIMM module by pushing it into the socket at an angle
(
Figure 4-2
).