IEI Technology PPC-3708, User Manual

Page: 72 / 161

PPC-3708/PPC-3710/PPC-3712 Panel PC
PPC-3712 flat panel PC chassis. The panel section that is cut out must be
smaller than the size of the aluminum frame that surrounds the 12.1” TFT LCD
panel but just large enough for the chassis to fit through (
Figure 3-27
).
Figure 3-27: Suggested Panel Cut Out Size for PPC-3712
Step 4:
Slide the PPC-3712 through the hole until the aluminum frame is flush against
the panel.
Step 5:
Insert the panel mounting clamps into the pre-formed holes along the edges of
the chassis, behind the aluminum frame. There are a total of 8 panel mounting
clamps.
Step 6:
Tighten the screws that pass through the panel mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the panel (
Figure 3-28
).
Step 0:
Page 72