IEI Technology PM-LX2-800, User Manual, Page: 64 / 123

PM-LX2-800 User Manual
Page 64
4.8.4 Single RS-232 Cable (without Bracket)
The single RS-232 cable consists of one serial port connector attached to a serial
communications cable that is then attached to a D-sub 9 male connector. To install the
single RS-232 cable, please follow the steps below.
Step 1: Locate the connector . The location of the RS-232 connector is shown in
Section 3.1.1 .
Step 2: Insert the cable connector . Insert the connector into the serial port box header.
See Figure 4-8. A key on the front of the cable connectors ensures the
connector can only be installed in one direction.
Figure 4-8: Single RS-232 Cable Installation
Step 3: Secure the bracket . The single RS-232 connector has two retention screws
that must be secured to a chassis or bracket.
Step 4: Connect the serial device . Once the single RS-232 connector is connected to
a chassis or bracket, connect a serial communications device to the chassis or
bracket.