IEI Technology PCIE-Q870-i2, User Manual

Page: 76 / 182

PCIE-Q870-i2 PICMG 1.3 CPU Card
Page 60
Step 4: Seat the iRIS-2400 module . Gently push downwards and the arms clip into
place ( Figure 4-12 ). Step 0:
NOTE:
After installing the iRIS-2400 module, use LAN2 port to establish a
network connection. Please refer to Section 4.8 for IPMI setup
procedures.
4.5.3 SATA Drive Connection
The PCIE-Q870-i2 is shipped with two SATA drive cables. To connect the SATA drives to
the connectors, please follow the steps below.
Step 1: Locate the connectors . The locations of the SATA drive connectors are shown
in Chapter 3 .
Step 2: Insert the cable connector . Insert the cable connector into the on-board SATA
drive connector until it clips into place. See Figure 4-13 .
Figure 4-13: SATA Drive Cable Connection