IEI Technology NANO-QM871-i1-i7, User Manual

Page: 64 / 159

NANO-QM871-i1 EPIC SBC
Page 51
Figure 4-4: SO-DIMM Installation
Step 1: Locate the SO-DIMM socket . Place the NANO-QM871-i1 on an anti-static pad
with the solder side facing up.
Step 2: Align the SO-DIMM with the socket . Align the notch on the memory with the
notch on the memory socket.
Step 3: Insert the SO-DIMM . Push the memory in at a 20º angle. (See Figure 4-4 )
Step 4: Seat the SO-DIMM . Gently push downwards and the arms clip into place. (See
Figure 4-4 )
4.5 iRIS-1010 Module Installation
WARNING:
The iRIS module slot is designed to install the iRIS-1010 module only.
DO NOT install other modules into the iRIS module slot. Doing so may
cause damage to the NANO-QM871-i1.
To install the iRIS-1010 module, please follow the steps below.
Step 1: Locate the iRIS module slot . The iRIS module slot is located on the solder side
of the motherboard. See Figure 3-10 .
Step 2: Remove the retention screw . Remove the retention screw as shown in
Figure 4-5 .