IEI Technology NANO-GM45A2-R10, User Manual

Page: 55 / 148

NANO-GM45A2 EPIC SBC
Page 43
Description Label Type
AT Power Mode Setting J_A/T1 2-pin wafer
Clear CMOS CLR_CMOS1 3-pin header
LVDS Panel Resolution PA_ID1 8-pin header
LVDS Voltage Select J2 6-pin header
Table 4-1: Jumpers
4.5.1 AT Power Select Jumper Settings
NOTE:
The AT Power Select Jumper is the same as the ATX Enable
connector.
Jumper Label:
J_A/T1
Jumper Type:
2-pin header
Jumper Settings:
See Table 4-2
Jumper Location:
See Figure 4-5
The AT Power Select jumper specifies the systems power mode as AT or ATX. AT Power
Select jumper settings are shown in Table 4-2 .
AT Power Select Description
Short 1 – 2 Use AT power Default
Open Use ATX power
Table 4-2: AT Power Select Jumper Settings
The location of the AT Power Select jumper is shown in Figure 4-5 below.