IEI Technology KINO-HM551, User Manual, Page: 70 / 126

KINO-HM551
Page 58
4.7.1 Dual RS-232 Cable with Slot Bracket
The dual RS-232 cable slot connector consists of two connectors attached to two
independent cables. Each cable is then attached to a D-sub 9 male connector that is
mounted onto a slot. To install the dual RS-232 cable, please follow the steps below.
Step 1: Locate the connectors . The locations of the RS-232 connectors are shown in
Chapter 3 .
Step 2: Insert the cable connectors . Insert one connector into each serial port box
headers. See Figure 4-12. A key on the front of the cable connectors ensures
the connector can only be installed in one direction.
Figure 4-12: Dual RS-232 Cable Installation
Step 3: Secure the bracket . The dual RS-232 connector has two D-sub 9 male
connectors secured on a bracket. To secure the bracket to the chassis please
refer to the reference material that came with the chassis.