IEI Technology KINO-CV-D25501, User Manual

Page: 61 / 120

KINO-CV-D25501/N26001 SBC
Page 49
Before and during the installation of the KINO-CV-D25501/N26001 DO NOT:

DO NOT remove any of the stickers on the PCB board. These stickers are
required for warranty validation.

DO NOT use the product before verifying all the cables and power connectors
are properly connected.

DO NOT allow screws to come in contact with the PCB circuit, connector pins,
or its components.
4.3 SO-DIMM Installation
To install a SO-DIMM, please follow the steps below and refer to Figure 4-1 .
Figure 4-1: SO-DIMM Installation
Step 1: Open the SO-DIMM socket handles . Open the two handles outwards as far as
they can. See Figure 4-1 .
Step 2: Align the SO-DIMM with the socket . Align the SO-DIMM so the notch on the
memory lines up with the notch on the memory socket. See Figure 4-1 .
Step 3: Insert the SO-DIMM . Once aligned, press down until the SO-DIMM is properly
seated. Clip the two handles into place. See Figure 4-1 .