IEI Technology KINO-9152G4, User Manual, Page: 102 / 232

KINO-9152G4 Mini-ITX Motherboard
Page 82
WARNING:
Do not wipe off (accidentally or otherwise) the pre-sprayed layer of
thermal paste on the bottom of the heat sink. The thermal paste
between the CPU and the heat sink is important for optimum heat
dissipation.
To install the cooling kit, please follow the steps below.
Step 1: Place the cooling kit onto the CPU . Make sure the CPU cooling fan cable
can be properly routed when the cooling kit is installed.
Step 2: Properly align the cooling kit . Make sure its four spring screw fasteners can
pass through the pre-drilled holes on the PCB.
Step 3: Secure the cooling kit . From the solder side of the PCB, align the support
bracket to the screw threads on heat sink that were inserted through the PCB
holes. (See Figure 5-4 )
Figure 5-4: Cooling Kit Support Bracket
Step 4: Tighten the screws . Use a screwdriver to tighten the four screws. Tighten each
nut a few turns at a time and do not over-tighten the screws.