IEI Technology KINO-780AM2, User Manual

Page: 55 / 131

KINO-780AM2 Motherboard
Page 43
Step 3: Insert the DIMM . Once properly aligned, the DIMM can be inserted into the
socket. As the DIMM is inserted, the white handles on the side of the socket will
close automatically and secure the DIMM to the socket. See Figure 4-6.
Step 4: Removing a DIMM . To remove a DIMM, push both handles outward. The
memory module is ejected by a mechanism in the socket. Step 0:
4.4 Jumper Settings
NOTE:
A jumper is a metal bridge that is used to close
an electrical circuit. It consists of two metal pins
and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
Before the KINO-780AM2 is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the KINO-780AM2 are listed in
Table 4-1.
Description Label Type
Clear CMOS J_CMOS1 3-pin header
Table 4-1: Jumpers
4.4.1 Clear CMOS Jumper
Jumper Label: J_CMOS1
Jumper Type:
3-pin header
Jumper Settings: See Table 4-2
Jumper Location:
See Figure 4-7