IEI Technology IVS-300, User Manual

Page: 29 / 107

IVS-300 Embedded System
Page 15
be carried out by qualified personnel who are familiar with the associated
dangers.

Air Circulation
: Make sure there is sufficient air circulation when installing the
IVS-300. The IVS-300’s cooling vents must not be obstructed by any objects.
Blocking the vents can cause overheating of the IVS-300. Leave at least 5 cm
of clearance around the IVS-300 to prevent overheating.

Grounding
: The IVS-300 should be properly grounded. The voltage feeds
must not be overloaded. Adjust the cabling and provide external overcharge
protection per the electrical values indicated on the label attached to the back
of the IVS-300.
3.2.1 High Surface Temperature
WARNING:
Some surfaces of the equipment may become hot during operation.
The surface temperature may be up to several tens of degrees hotter
than the ambient temperature. Under these circumstances, the
equipment needs to be protected against accidental contact.
The equipment is intended for installation in a RESTRICTED ACCESS LOCATION.

Access can only be gained by SERVICE PERSONS or by USERS who have
been instructed about the reasons for the restrictions applied to the location
and about any precautions that shall be taken.

Access is through the use of a TOOL or lock and key, or other means of
security, and is controlled by the authority responsible for the location.
3.3 Installation Procedure
To properly install the IVS-300, the following steps must be followed. Detailed descriptions
of these instructions are listed in the sections that follow.
Step 1:
Unpacking the IVS-300 embedded system