IEI Technology IVS-110, Manual

Page: 94 / 119

IVS-110 Embedded System
Page 80
Step 3: Make the jumper settings in accordance with the settings described and defined
in the following sections. Step 0:
5.3.1 TXE Override Jumper
The TXE Override jumper (J_FLASH1) allows users to enable or disable the TXE firmware
update. Refer to Figure 5-1 and Table 5-1 for the jumper location and settings.
Setting Description
Short 1-2 Disabled (default)
Short 2-3 Enabled
Table 5-1: TXE Override Jumper Settings
Figure 5-1: TXE Override Jumper Location
To update the TXE firmware, please follow the steps below.
Step 1: Before turning on the system power, short pin 2-3 of the TXE Override jumper.
Step 2: Update the BIOS and TXE firmware, and then turn off the system power.
Step 3: Remove the metal clip on the TXE Override jumper or return to its default setting
(short pin 1-2).
Step 4: Restart the system. The system will reboot to complete the TXE firmware update.
Step 0: