IEI Technology ITG-100-AL, User Manual

Page: 34 / 107

ITG-100-AL Embedded System
Page 22
3.6 Additional Block Layer Installation
NOTE:
Additional block layer can be assembled to achieve I/O interface
expansion and data storage requirement. With choices of adding a 2.5”
SATA HDD/SSD bay, a knockout-hole layer with selectable I/O
interface, or both of above-mentioned options, the ITG-100-AL could
be modularized to what best fit users’ preferences and still remaining
its compact size.
To install the additional block layer, please follow the steps below:
Step 1: Remove the bottom panel by removing the two retention screws from the bottom
panel ( Figure 3-11 ).
Figure 3-11: Remove the Bottom Panel (ITG-100-AL-E1/S)
Step 2: Install the additional block layer by securing the four retention screws.
( Figure 3-12 ).