IEI Technology ISIGNAGER - 800WL-N270, User Manual

Page: 41 / 67

iSignager-800WL-N270 Digital Signage Player
Page 33
Step 6: Secure the HDD to the iSignager-800WL-N270 . Align the retention screw
holes in the HDD bracket with the retention screw holes on the
iSignager-800WL-N270. Insert the two previously removed retention screws.
Step 7: Close and lock the protection cover. Step 0:
3.5.2 Memory Module Replacement
The flat panel PC is preinstalled with a 1.0 GB DDR2 memory module. If the memory
module is fail, follow the instructions below to replace the memory module.
Step 1: Remove the top cover. See Section 3.4.1 above.
Step 2: Locate the DDR2 SO-DIMM on the motherboard ( Figure 3-7 ).
Figure 3-7: SO-DIMM Socket Location
Step 3: Remove the DDR memory module by pulling both the spring retainer clips
outward from the socket.
Step 4: Grasp the DDR memory module by the edges and carefully pull it out of the
socket.
Step 5: Install the new DDR memory module by pushing it into the socket at an angle
( Figure 3-8 ).