IEI Technology iSignager-1000-Q354, User Manual

Page: 142 / 189

iSignager-1000-Q354 Digital Signage Player
Page 128
Step 4:
Disconnect the SATA cable from the rear of the HDD.
Step 5:
Remove the HDD bracket from the side of the iSignager-1000-Q354 chassis.
Step 6:
Remove the HDD from the HDD bracket by removing the four retention screws
on the bottom of the HDD (
Figure 8-8
).
Step 0:
Figure 8-8: HDD Retention Screws
8.4.2.2 HDD Installation
To install the new HDD, please follow the steps below.
Step 1:
Attach the new HDD to the HDD bracket. To do this, slide the HDD into the HDD
bracket to connect the rear of HDD with the cable connector.
Step 2:
Align the four retention screw holes in the bottom of the HDD with the retention
screw holes on the bottom of the HDD bracket. Insert four previously removed
retention screws into the bracket on the bottom of the HDD (
Figure 8-8
).
Step 3:
Reinstall the HDD into the iSignager-1000-Q354 by aligning the retention screw
holes in the top of the HDD bracket with the retention screw holes on the chassis.
Insert the four previously removed retention screws into the top of the HDD
bracket (
Figure 8-7
).
Step 4:
Reconnect the SATA and power cable connector.
Step 0: