IEI Technology ISDM-084G, User Manual

Page: 104 / 152

ISDM Series Industrial Monitor
Page 104
5.5.2 Wall Mounting
To mount the ISDM series industrial monitor onto a wall, please follow the steps below.
Step 4:
Select a location on the wall for the wall-mounting bracket.
Step 5:
Carefully mark the locations of the four bracket screw holes on the wall.
Step 6:
Drill four pilot holes at the marked locations on the wall for the bracket retention
screws.
Step 7:
Align the wall-mounting bracket screw holes with the pilot holes.
Step 8:
Secure the mounting-bracket to the wall by inserting the retention screws into
the four pilot holes and tightening them (
Figure 5-11
).
Figure 5-11: Wall-mounting Bracket
Step 9:
Insert the four monitor mounting screws provided in the wall mounting kit into the
four screw holes on the real panel of the monitor and tighten until the screw
shank is secured against the rear panel (
Figure 5-12
).