IEI Technology IMBA-C2260-i2, User Manual, Page: 80 / 166

IMBA-C2260-i2 ATX Motherboard
Page 66
NOTE:
After installing the iRIS-2400 module, use LAN1_USB2 port to
establish a network connection. Please refer to Section 4.8 for IPMI
setup procedures.
4.4 mSATA Card Installation
To install an mSATA card, please follow the steps below.
Step 1: Locate the mSATA card slot . The location of the mSATA card slot is shown in
Chapter 3 .
Step 2: Remove the retention screws . Remove the two retention screws secured on
the motherboard as shown in Figure 4-8 .
Figure 4-8: Remove the Retention Screws for the mSATA Card
Step 3: Insert into the socket at an angle . Line up the notch on the card with the notch
on the connector. Slide the mSATA card into the socket at an angle of about 20º
( Figure 4-9 ).