IEI Technology IMBA-9454B, User Manual

Page: 74 / 192

IMBA-9454B ATX Motherboard
Page 58
Pins Description
Open AT
Short ATX Default
Table 5-2: CF Master/Slave Selection Settings
5.5.2 Clear CMOS Jumper
Jumper Label: JP1
Jumper Type:
3-pin header
Jumper Settings: See Table 5-3
Jumper Location: See Figure 5-8
If the IMBA-9454B fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1
and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
ƒ
Enter the correct CMOS setting
ƒ
Load Optimal Defaults
ƒ
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in Table 5-3 .
Pins Description
1-2 Keep CMOS Setup Default
2-3 Clear CMOS Setup
Table 5-3: Clear CMOS Jumper Settings