IEI Technology imba-30104, User Manual

Page: 70 / 185

IMBA-30104 ATX Motherboard
Page 56
4.6 Jumper Settings
NOTE:
A jumper is a metal bridge that is used
to close an electrical circuit. It consists
of two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
Before the IMBA-30104 is installed in the system, the jumpers must be set in accordance
with the desired configuration. The jumpers on the IMBA-30104 are listed in Table 4-1 .
Description Label Type
Clear CMOS J_CMOS1 3-pin header
Table 4-1: Jumpers