IEI Technology IDS-310-AL, User Manual

Page: 29 / 114

IDS-310-AL Embedded System
Page 15
3.3 Bottom Surface Removal
Before internal devices can be installed, the bottom surface must be removed. To remove
the bottom surface, please follow the steps below:
Step 1:
Remove the bottom surface retention screws. The bottom surface is secured to
the chassis with four (4) retention screws ( Figure 3-1 ). All four (4) screws must
be removed.
Figure 3-1: Bottom Surface Retention Screws
Step 2: Gently lift and remove the bottom surface from the IDS-310-AL. Step 0:
Figure 3-2: Bottom Surface Removal