42
Appendix B How to use Wake-Up Function
The ICPMB-7880 provides two kind of Wake up Function.
This page describes how to use Modem Wake-Up and LAN Wake-Up function.
Wake-Up function is working while you use ATX power supply,
Wake – Up On Modem(Ring)
:
You must set the option
Resume on Ring/LAN
of CMOS SETUP to be enabled.
The ATX power supply will be switched on when there is a ring signal detected on
pin “RI” of serial port.
Wake-Up On LAN
:
When your computer is in power-down status in Windows OS , you can see LAN
Link/Active LED is flashing. This status indicates that the LAN chip has entered
standby mode and waits for Wake-Up signal. You can use other computers to
wake up your computer by sending ID to it.
ID: ID is the address of your system LAN. Every LAN chip has a factory-set ID,
which you can find it from network information in WINDOWS.
ID’s format is xxxxxxxxxxxx
Example ID
: 009027388320
