IEI Technology IBX-700 Series, User Manual

Page: 155 / 218

IBX-700 Integrated Service Computer
Page 137
Figure 8-16: ODD Retention Screws
8.4.5.2 ODD Installation
To install the new ODD, please follow the steps below.
Step 1:
Attach the new ODD to the ODD bracket. Align the four retention screw holes in
both side of ODD with the retention screw holes on the side of the ODD bracket.
Insert the four previously removed retention screws into the bracket on both
sides of the ODD (
Figure 8-16
).
Step 2:
Attach the SATA cable to the ODD by aligning the two retention screw holes in
the SATA cable with the retention screw holes on the rear of the ODD. Insert two
retention screws into the SATA cable (
Figure 8-15
).
Step 3:
Reinstall the ODD into the IBX-700 by aligning the retention screw holes in the
top of the ODD bracket with the retention screw holes on the chassis. Reinsert
the two previously removed retention screws into the ODD bracket (
Figure
8-14
).
Step 4:
Reconnect the SATA and power cable connectors from the rear of ODD to the
motherboard and the power module.
8.4.6 Riser Card Replacement (Optional)
Step 5:
Remove the cover case. See
Section 8.3.1
.