IEI Technology F15AD-H81i/PC-R10, User Manual

Page: 52 / 185

PPC-FxxA-H81 Panel PC
Page 37
Step 3: Align the iRIS-2400 module with the iRIS-2400 module slot
. Align the notch
on the module with the notch on the iRIS-2400 module slot (
Figure 3-24
).
Figure 3-24: iRIS-2400 Module Installation
Step 4: Insert the iRIS-2400 module
. Push the module in at a 20º angle (
Figure 3-24
).
Step 5: Seat the iRIS-2400 module
. Gently push downwards and the arms clip into
place (
Figure 3-24
).
Step 0:
NOTE:
After installing the iRIS-2400 module, use the LAN port with
iRIS
label
(
Figure 1-4
) to establish a network connection. Please refer to
Section 3.13
for IPMI setup procedures.
3.10 AT/ATX Mode Selection
AT and ATX power modes can both be used on the PPC-FxxA-H81 panel PC. The
selection is made through an AT/ATX switch on the I/O interface panel. The switch is
shown below.