EP-308A POS
Page 15
Figure 2-7: USB Device Connection
Step 3:
Insert the device connector.
Once aligned, gently insert the USB device
connector into the onboard connector.
Step 0:
2.5.4 VGA Monitor Connection
The EP-308A has a single female DB-15 connector on the external peripheral interface
panel. The DB-15 connector is connected to a CRT or VGA monitor. To connect a monitor
to the EP-308A, please follow the instructions below.
Step 1:
Locate the female DB-15 connector
. The location of the female DB-15
connector is shown in
Chapter 3
.
Step 2:
Align the VGA connector
. Align the male DB-15 connector on the VGA screen
cable with the female DB-15 connector on the external peripheral interface.
Step 3:
Insert the VGA connector
.
Once the connectors are properly aligned with the
insert the male connector from the VGA screen into the female connector on the
EP-308A. See Figure 2-8.
Summary of Contents for EP-308A
