IEI Technology ECW-281B-945GSE, User Manual

Page: 67 / 167

ECW-281B Embedded System
Page 51
Figure 4-6: Mounting Bracket Retention Screws
Step 4:
Drill holes in the intended installation surface.
Step 5:
Align the mounting holes in the sides of the mounting brackets with the predrilled
holes in the mounting surface.
Step 6:
Insert four retention screws, two in each bracket, to secure the system to the
wall.
Step 0:
4.2.7 Mounting the System with Wall Mount Kit
To mount the embedded system onto a wall using the VESA MIS-D 100 wall mount kit,
please follow the steps below.
Step 1:
Select the location on the wall for the wall-mounting bracket.
Step 2:
Carefully mark the locations of the four bracket screw holes on the wall.
Step 3:
Drill four pilot holes at the marked locations on the wall for the bracket retention
screws.
Step 4:
Align the wall-mounting bracket screw holes with the pilot holes.
Step 5:
Secure the mounting-bracket to the wall by inserting the retention screws into
the four pilot holes and tightening them (
Figure 4-7
).