IEI Technology ECN-360A-ULT3, User Manual

Page: 30 / 131

E C N-360A-ULT3 E mbedded S ys tem
P age 17
S tep 7:
Reinstall the cover that was previously removed in the same position it was
before.
3.4 Mounting the S ys tem with Mounting B rackets
To mount the embedded system onto a wall or some other surface using the two mounting
brackets, please follow the steps below.
S tep 1:
Turn the embedded system over.
S tep 2: Align the two retention screw holes in each bracket with the corresponding
retention screw holes on the sides of the bottom surface ( Figure 3-6 ).
Figure 3-6: Mounting Bracket Retention Screws
S tep 3:
Secure the brackets to the system by tightening two retention screws into each
bracket ( Figure 3-6 ).
S tep 4: Drill holes in the intended installation surface.
S tep 5:
Align the mounting holes in the sides of the mounting brackets with the predrilled
holes in the mounting surface.
S tep 6:
Insert four retention screws, two in each bracket, to secure the system to the
wall.
S tep 0: