IEI Technology DM-F12A/PC-R10, User Manual

Page: 40 / 91

DM-F S e rie s Mo n ito r
P a g e 30
When mounting the monitor take care to tighten the retention screws or bolts
until fully secure, but do not over tighten. Over tightening the retention screws
or bolts may cause them to become stripped, rendering them useless.
4.4.1 P a n e l Mo u n tin g
Each model of the DM-F series LCD monitor has a series of mounting slots located on the
top and bottom panel for mounting the monitor to a panel.
Table 4-7 lists the number of mounting clamps required to mount the monitor to a panel.
Mo d e l Mo u n tin g Cla m p s
DM-F12A 9
DM-F15A 9
DM-F17A 9
DM-F22A 10
DM-F24A 12
Table 4-7: Panel Mounting Clamps
To mount the DM-F series LCD monitor into a panel, please follow the steps below.
S te p 1: Select the position on the panel to mount the monitor.
S te p 2:
Cut out a section of the panel that corresponds to the rear panel dimensions of
the monitor. Take care that the panel section that is cut out is smaller than the
overall size of the metal frame that surrounds the monitor but just large enough
for the rear panel of the monitor to fit through.