IEI Technology AFL3-W15C-ADLP, User Manual

Page: 38 / 156

AFL3-W15C/W19C/W22C-ADLP
Page 22
 Anti-static Discharge : If a user open the rear panel of the flat bezel panel
PC, to configure the jumpers or plug in added peripheral devices, ground
themselves first and wear an anti-static wristband.
3.3 Installation and Configuration Steps
The following installation steps must be followed.
Step 1: Unpack the flat bezel panel PC.
Step 2: Install an M.2 module or a HDD.
Step 3: Configure the system.
Step 4: Connect peripheral devices to the flat bezel panel PC.
Step 5: Mount the flat bezel panel PC. Step 0:
3.4 Removing the Back Covers
To access the AFL3-W15C/W19C/W22C-ADLP internally the plastic back cover and the
internal aluminum cover must be removed. To remove the covers, please follow the steps
below.
Step 1: Remove the retention screws from the back cover. Two types of screw are used
for securing the plastic cover of the AFL3-W15C-ADLP. See Figure 3-1 for detail.
Be aware of this for reinstalling the plastic cover.