IEI Technology AFL3-W15C-ADLP, User Manual, Page: 53 / 156

AFL3-W15C/W19C/W22C-ADLP
Page 37
Step 4: Insert a M5*50 screw into the screw hole on the side of the panel mounting
bracket. Then, install the following components onto the screw in sequence.
See Figure 3-20 .
Sequence Item Photo Instruction
1 Spring Install a spring onto the screw.
2 Nut Tighten a nut until the spring is
compressed enough for plastic
cap.
3 Plastic
cap
Tighten a plastic cap onto the end
of screw thread.
Step 5: Repeat Step 4 to install the other three screws into the sides of the two panel
mounting brackets.
Figure 3-20: Panel Mounting Kit Installation
Step 6: Align the panel mounting bracket screw holes with the VESA mounting holes on
the rear of the panel PC.