IEI Technology AFL2-12A-D525 Series, User Manual

Page: 69 / 180

AFL2-12A-D525 Series Panel PC
Page 69
Step 8: Install the new DDR3 memory module by pushing it into the socket at an angle
( Figure 5-3 ).
Step 9: Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down ( Figure 5-3 ).
Step 10: Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR memory module in the socket.
Figure 5-3: DDR SO-DIMM Module Installation
Step 11: Replace the internal aluminum cover and secure it to the chassis using six (6)
retention screws.
Step 12: Replace the back cover and secure it using nine (9) previously removed
retention screws. Step 0:
5.5.2 WLAN Card Replacement
The AFL2-12A-D525 has one WLAN card slot. To replace the WLAN card, follow the
instructions below.
Step 1: Follow all anti-static procedures. See Section 5.2 .
Step 2: Turn off the power. See Section 5.3 .
Step 3: Remove the back cover. See Section 5.4.1 .
Step 4: Remove the internal aluminum back cover. See Section 5.4.2 .