IEI Technology AFL-W10A-N270, User Manual

Page: 56 / 158

AFL-W10A-N270 User Manual
Page 56
3.4 Memory Module Replacement
The panel PC is preinstalled with a 1 GB DDR2 memory module. If the memory module is
fail, follow the instructions below to replace the memory module.
Step 1:
Remove the aluminum back cover. See
Section 3.3
above.
Step 2:
Locate the DDR2 SO-DIMM on the motherboard (
Figure 3-4
).
Figure 3-4:AFL-W10A-N270 SO-DIMM Socket Location
Step 3:
Remove the DDR memory module by pulling both the spring retainer clips
outward from the socket.
Step 4:
Grasp the DDR memory module by the edges and carefully pull it out of the
socket.
Step 5:
Install the new DDR memory module by pushing it into the socket at an angle
(
Figure 3-5
).
Step 6:
Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down (
Figure 3-5
).
Step 7:
Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR memory module in the socket.
Step 0: