IEI Technology AFL-08AH-N270-CR, User Manual

Page: 57 / 115

AFL-08AH-N270-CR Panel PC
Page 43
Step 4:
Remove the DDR memory module by pulling both the spring retainer clips
outward from the socket.
Step 5:
Grasp the DDR memory module by the edges and carefully pull it out of the
socket.
Step 6:
Install the new DDR memory module by pushing it into the socket at an angle
(
Figure 5-4
).
Step 7:
Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down (
Figure 5-4
).
Step 8:
Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR memory module in the socket.
Step 0:
Figure 5-4: DDR SO-DIMM Module Installation
5.5.2 CF Card Replacement
The AFL-08AH-N270-CR is preinstalled one CF Type II card. To replace the CF card,
follow the instructions below.
Step 1: Follow all anti-static procedures
. See
Section 5.2
.
Step 2: Turn off the power
. See
Section 5.3
.
Step 3: Remove the back cover
. See
Section 5.4.1
.
Step 4:
Locate the CF slot. Remove the old CF card (
Figure 5-5
).