Wireless Receiver Mounting Bracket
A-MWR
Thank you for purchasing the A-MWR. This Bracket is an optional adaptor designed to fit
a wireless receiver,HDD and other accessories onto a camcorder together with V-Mount
batteries. Prior to using the A-MWR, IDX recommend to read this Instruction Manual on
how to best use this Bracket and recommend to keep this manual for your reference.
●
This bracket can be attached directly to the V-Mount type camcorder without using screws.
●
This bracket can be attached to the V-Mount on CW-5HD and AC-100.
●
Plate depth can be adjusted to four different position therefore the A-MWR is now compat-
ible with all ENDURA batteries and fit in PowerLink configuration.
●
Wireless receiver and HDD can be attached to either side of the bracket simulteneously.
●
D-Tap connector supplies DC power directly from the battery allowing powered for on-board
camera light such as X5-Lite, etc..
●
Rear panel can be removed if it is not used.
●
Maximum output for the D-Tap: 50W
●
Dimensions:
115(W)×153(H)×102-153(D)
㎜
4.53(W)×6.02(H)×4.02
-
6.02(D)inches.
●
Weight:approx. 520g / 1.15lbs.
●
Do not attempt to modify this unit. All
work should be carried out by IDX
authorized service personnel only.
●
When connecting a battery or adaptor to
the A-MWR, be sure connect firmly. If it
is not attached properly, it may result in
loss or damage to the unit or even injury
to the user.
●
If you need any inspection or repairs,
please contact your IDX dealer or
appropriate IDX office.
V-Mount / Video Camera
ENDURA Battery
HDD
Wireless Receiver
D-Tap
General Notes and Safety
Adjustment of depth
Set up
Specifications
Features
To set up the A-MWR, follow by below drawing.
Supports PowerLink configulation.
Tighten and hold with the screw
included in HDD recorder.
Can be attached to
the V-Mount on CW-5HD and AC-100
DC output for an on-board camera light
and other DC operated accessory.
Set the mounting bracket by
using the 4 × screws to the
A-MWR as discrived in drawing.
Example of use
Accessories can be fitted to either
side of the bracket.
wire clip &
M3 tapping screw
screw
M3 screw×2
M4 screw×2
Instruction Manual
Design and specification are subject to change without notice.
201006
●
The depth of A-MWR can be set in four
different positions to suit your battery
set up. To adjust the depth, loosen the
screws on either side and adjust at
best position then tighten the screws
again.
●
Rear panel can be removed if it is not
needed.
Rear panel
M4 bracket
M3 bracket
