iDTRONIC ID LOCK 6000, Manual

Page: 5 / 6

Rev. 02 | English | 5
Operation
b) Per Master-card
1. Hold the master-card in front of the knob six times
in a row.
2. Two beep sounds confirm the successful process.
3
Switching Modes (using the Mode-card)
1. Hold the master-card in front of the knob.
2. Hold the mode-card in front of the knob.
3. One long beep for private-mode or three long
beeps for multiuser-mode confirm the successful
process.
4. Remove the mode-card from the lock.
Note: During this process, all cards (master-
cards, manager-cards, and user-cards) will
be deleted.
1
Private-mode
a) Opening
1. Hold the user-card in front of the knob. A longer
beep sound and the green LED confirm the
successful process.
2. Within 3 seconds, turn the knob to the right
(clockwise) and pull open the door.
Note: Unauthorized cards will be rejected by the lock
with three consecutive beep sounds .
b)
Closing
The lock will automatically close within 4 seconds.
The LED briefly blinks. To close, turn the knob to
the left (counterclockwise) until it locks into place.
2
Multiuser-mode
a) Closing
1. Hold the user-card in front of the knob. A beep sound
and the red LED confirm the successful process.
2. To close, turn the knob to the left (counterclockwise)
until it locks into place.
b) Opening
1. Hold the user-card in front of the handle, in the center.
A longer beep and the green LED will confirm the
successful process.
2. Rotate the handle clockwise within 3 seconds and pull
open the door.
Note: Unauthorized cards will be rejected by the lock
with three consecutive beeps. .
Emergency Power Supply
If the batteries do not have sufficient voltage, an external
power supply can be connected via the Micro-USB port. To
do this, the touchpad needs to be connected to a power
source such as a power adapter, notebook, or power bank
using a Micro-USB cable. The lock can then be operated
again.
Note: We recommend replacing the batteries promptly.
Swapping Batteries
2. Remove the battery compartment as shown in the illustration
and replace the battery. Insert the battery according to the
symbols (+ / -) (see page 2).
Note: The surface of the battery must be free from residue
and fingerprints, as it may cause disturbances. If the surface
is dirty, clean it with a dry cloth.
If the lock displays a low battery level, the battery should be
replaced promptly.
Note: The lock is approved for use with VARTA brand
batteries. The use of other batteries may result in a reduced
number of possible locking cycles.
1. Press the reset-PIN into the side opening of the lock according
to the illustration. Rotate the housing slightly to the left and pull
it forward.
3. Insert the battery compartment and push the housing back onto
the lock. Rotate the housing until it clicks into place.
ID LOCK 6000 | 07-2023