24
※
iTDC Quick Installation Guide
Mar.11.2010
4. SYSTEM INITIALIZATION
After all wiring process is done, you must initialize the iTDC/iTDC-SR.
Initialization is used to clear all data stored in the controller and reload default setting values (factory setting values).
During production and test process of the device, arbitrary setting values may be saved. Thus, restore it to default values by
Initialization.
Initialization switches are on the upper right side of iTDC/iTDC-SR. Press two initialization switches and then keep it for more
than 2 seconds then, beep sound will be generated.
Once beep sound is generated, release the switches then initialization process is starting. After initialization process is done, the
system restarts and then you can hear 2 beep sounds.
If the Controller is initialized, all ID information and event data stored in the Controller will be
cleared. Therefore, the Initialization should be performed by authorized person only. It is
strongly recommended to upload all ID information and events data before initialization.
After the initialization, you should transmit ID, Time, and Door definition from software to the
device.
Caution
Press simultaneously
