ZSSC4151 Evaluation Kit Hardware Manual
© 2016 Integrated Device Technology, Inc.
5
March 11, 2016
2
ZSSC415x/6x/7x Evaluation Board
2.1.
Overview
Note: See section 2.2 for the SSC EB schematic, including pin names for the CB (Bu1) and SRB (K10) connectors.
Figure 2.1 ZSSC415x/6x/7x SSC Evaluation Board – Overview
Table 2.1
ZSSC415x/6x/7x Evaluation Board Connectors, Switches, and LEDs
Name
Description
D1
Status LED for the KS5V supply. Its forward current is not included in the measured supply current.
Bu1
50-pin female connector connected to the SSC CB. See section 2.3 for descriptions of the signals on Bu1.
K10
50-pin male connector to the SRB. See section 2.4 for descriptions of the signals on K10.
KL1
On-board screw terminal for GND (VSSE), VDDE2 (to VDDE), VDDA, and TS1 connections.
KL2
On-board screw terminal for TS2, VSSA, TOP, and BR2P (not applicable to ZSSC4151).
KL3
On-board screw terminal for BR2N (not applicable), BR1P (to BRP), BR1N (to BRN), and BOT.
K1, K9
Powers (enables) the headers for connecting external Sensor 1 or Sensor 2 modules (K2 and K5 respectively) via KS5V.
K2, K5
Headers for connections for external Sensor 1 or Sensor 2 modules.
K4, K6
Strips for access to all ZSSC4151 signals; can be used to connect directly to the ZSSC4151 for in-circuit programming.
K7
Connects KS5V supply to VDDE pin (leave open when external power supply VDDE2 is connected); provides test points
for simple supply current measurements.
K8
C
onnects the external SRB temperature sensor to the IC’s TS1 or TS2 inputs.
S1
Switch that is used for interface selection during programming and calibration (set to OWI for ZSSC4151 IC).
QFN-24
Socket for inserting the QFN 4x4mm ZSSC4151 DUT.
K11
Mass Calibration Board (MCB) DUT connector.
