7
For some channel is allowed to over-rule the restriction temporary such as CH 13
& 67. Press and hold the PTT key and the Hi/Lo key to switch the Tx power to Hi
power temporarily until the either key is released.
B.5 16 Channel
Jump to either Channel 16 directly by pressing the 16 Key. Toggle between
Channel 16 at High Power. Press 16 key again will go back to last channel.
(channel before enter 16 mode )
16 key also can use to cancel all mode and switch to CH 16 HI power mode
independent the current Hi/Lo setting.
It will quit the menu mode and jump to CH16 directly when pressed.
B.6 BAND
Switch the operational channel band [USA, International & Canada ] in the setup
menu, see C3 for detail.
Please refer to the EEPROM channel table for detail. The corresponding icon will
turn on as indication.
B.7 Scan
In normal mode, long press the right soft key will act as Scan key function.
This is the function to scan for broadcasting channel. When available channel
detected, the receiver will stop at that channel and continue to search when that
transmission ceased.
There are 2 Scan mode available – ALL Scan; 3 CH Scan.
During the SCAN modes :
Press Up/Down key ( CH knob clockwise/anti-clockwise ) will change the scan
direction.
Press SCAN key again will terminate the scan operation and stop at the last used
channel.
Press EXIT key will also terminate the scan function and state at the last used
channel
WATCH or H/L key will be no function and sound an error beep if pressed.
