6. Event Management > Event Detection
CPS-1848 User Manual
136
June 2, 2014
Formal Status
This document is confidential and is subject to an NDA.
Integrated Device Technology
6.2.9.3.3
JTAG Error Encoding (Revision A/B Only)
The JTAG error displayed in the following table is detectable by the CPS-1848. If JTAG error reporting is enabled the error can
be sent to the Error Log when detected.
6.2.9.3.4
Configuration Event Encoding
The CPS-1848 can detect the configuration errors listed in
. If configuration error reporting is enabled each error can
be sent to the Error Log when detected.
6.2.9.3.5
Trace, Filter, and PGC Mode Event Error Log Encoding
The Trace, Filter and PGC mode events have their own special encoding that is not associated with any other status bits.
These events are listed in the following table.
Table 49: JTAG Errors and Codes (Revision A/B Only)
Error
Error Code
Corresponding Detect Bit in
Aux Port Error Detect Register
JTAG incomplete write
0x20
JTAG_ERR
Table 50: Configuration Errors and Codes
Error
Error Code
Corresponding Detect Bit in
Configuration Block Error Detect
Multicast mask configuration error
0x50
BAD_MASK
Port configuration error
0x53
BAD_PORT
Force local configuration error
0x54
RTE_FORCE
Route table configuration error
0x55
BAD_RTE
Multicast translation error
0x56
BAD_MCAST
Table 51: Trace, Filter, and PGC Mode Error Log Encoding
Error
Error Code
Trace match occurred
0x9E
Filter match occurred
0x9F
Packet Generation and Capture
Complete
0xA8