IDS GigE uEye CP Rev. 2, Technical Manual

Page: 13 / 23

January 2020 13
Technical Manual: GigE uEye CP Rev. 2
8 Electrical specifications
·
Pin assignment GigE connector (RJ45)
·
Pin assignment I/O connector
·
Digital input wiring
·
Digital output wiring
·
General Purpose I/O wiring
Exception: PoE may be considered a Network Environment 0 per IEC TR 62101, and thus
the interconnected ITE circuits may be considered SELV, if:
1. the function of the ITE being investigated to IEC 60950-1 is considered not likely to
require connection to an Ethernet network with outside plant routing, including campus
environment; and
2. the installation instructions clearly state that the ITE is to be connected only to PoE
networks without routing to the outside plant.
8.1 Pin assignment GigE connector (RJ45)
8-pin RJ45 socket
Pin Designation 100BASE-TX Designation 1000BASE-T
Fig. 5: RJ45
socket, camera
rear view
1 Tx+ Bl_DA+
2 Tx- Bl_DA-
3 Rx+ Bl_DB+
4 Bl_DC+
5 Bl_DC-
6 Rx- Bl_DB-
7 Bl_DD+
8 Bl_DD-
The RJ45 socket of the GigE uEye CP Rev. 2 complies with the IEC 60603-7 standard.
8.2 Pin assignment I/O connector
8-pin Hirose connector (HR25-7TR-8PA(73))
Pin Description
Fig. 6: Hirose
connector male,
camera rear view
1 Ground (GND)
2 Flash output with optocoupler (-)
3 General purpose I/O (GPIO) 1, 3.1 V
4 Trigger input with optocoupler (-)
5 Flash output with optocoupler (+)
6 General purpose I/O (GPIO) 2, 3.1 V
7 Trigger input with optocoupler (+)
8 Input power supply (VCC) 12-24 V DC
You can check the color assignment of the cable on the Website directly at the specific accessory item.
The maximum length of the I/O cable is 30 m. The cable must be shielded.