-4-
-4-
Loading the Roll
Loading the Ribbon
Rev.1.0
1.
Place the printer on the flat table, li� the
cover
from the bo�om-right of printer
by hands.
3. Pull a part of ribbon, then pass the ribon
between the print mechanism and the
media sensor.
4. Pass the ribbon over the print mechanism
and the ribbon take-up spindle, and then
wrap it serveral turns around the ribbon
take-up spindle.
！
Note
:
Please refer to windows driver installa�on in
iX4 Series
User Manual.
1
2
Varies by regions
2.Connect the other end of power cord to the AC
power port.
1.Connect the power plug to power receptacle.
Power Cord
Loading the Ribbon
An�clockwise
Clockwise
2. Load the out side ink ribbon into ribbon
supply spindle,
then an�clockwise �ghten
the ribbon latch to fix the ribbon.
-6-
-5-
2. Mount a label roll onto the media spindle. Be sure to push the roll all the way aligned
the inner wall of the printer.
A�er the label roll be loaded, put the media
guide back on
the media spindle. Then rotate
the arrow mark that locates in unlocking posi�on to
lock
posi�on so that it can be latched.
3.
Pull out part of label and pass it under the external media guide and media sensor un�l
it reaches
the exit slot. Then slide the media adjus�ng level
apart to adjust for the label
width.
Loading the Paper
5.
A�er finishing the label loading, turn down
the print head lever to make ribbon and label
fit
snugly.
1. Rotate the arrow mark that locates in media guide lock of media spindle to unlocking
posi�on
, then remove the media guide.
4. When using the gap label, black mark label or punch hole label, you can manually adjust
the media sensor by the adjus�ng level to find the gap, black mark or punch hole for the
start prin�ng posi�on
.
Media Sensor
External Media Guide
Connec�ng the Power
Loading the Paper
Media Adjus�ng Level
Media Adjus�ng Level
Ribbon
Print mechanism
Media Sensor
Ribbon Take-up Spindle
