Part 2 - Configuration
81
VA Box_Crowd Detection
An event occurs when a person is detected and the
maximum number of people is set in the unit area.
●
Set up :
Set the
Crowd Detection event.
-
Max People :
An event occurs when a person
stays in the area in excess of the number of
people set by a person.
-
Detection Reference Time :
Set the minimum
time required to be detected as a person in the
area.
To use the Crowd Detection, the Crowd
Detection must be set on that channel.
●
Actions:
Specify which actions to take when an event
occurs.
–
Record:
Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
–
Alarm-Out:
Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
–
Notify:
Configure to be notified of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
–
PTZ:
Moves the PTZ camera to a specific preset
position when an event occurs.
–
Event Monitoring:
Selects the cameras to monitor
when an event occurs.
VA Box_Social Distancing
Violation
Event occurs when the distance is less than the interval
that is set by estimating the distance between people by
human detection.
●
Set up :
Set the allowable interval between people.
-
Sensitivity :
The higher the sensitivity value, the
greater the probability of being detected as an event,
if the distance between people is equal to the step
relative value of the distance between people.
-
Ignoring Interval :
Event log and remote notification
are not performed for Social Distancing Violation
events detected within a certain period of time after
the event was detected.
To use the Social Distancing Violation, the
Social Distancing Violation must be set on
that channel.
