Idis DR-4516P, Quick Manual

Page: 8 / 36

8
Camera Registration
Once Network Setup Wizard is complete, live mode screen
appears. While in live mode, right-click on the mouse and
select Camera Registration to run the Camera Registration
mode. It allows you to scan for the cameras connected to
the NVR.
1
3
4
2
5
1
Camera Scan Button
2
Camera View
Buttons
3
Camera List Area
4
Video Display Area
5
Apply/Cancel
Buttons
Camera Scan Button
Use this button to scan for and register cameras.
Pressing the
Scan button displays the following submenu:
●
Rescan : Scan for DirectIP™ cameras that were not
scanned automatically.
● Go To Camera : Moves the focus automatically to the
camera using MAC address of camera in the camera list.
● Search Scope : Filters the cameras in the camera list
depending on the search scope such as specified IP
address range.
● Screen Auto. Assign
: Assigns the detected cameras on
the video display area.
●
Camera list : By using the camera information file, .csv,
the user can register the cameras easily.
● Scan Refresh Interval:
Configures the refesh interval
to scan the camera. If the interval is short, camera scan
results are refreshed more frequently. However, if the
interval is long, it is advantageous to scan cameras on a
wide network.
● Third Party Scan : Used to manually scan for third-party
cameras that cannot be recognized by the auto scan
feature.
- Protocol: Select the protocol used by the camera (or
video encoder) you wish to search for.
Even if the network device uses a protocol
supported by the NVR, the device itself may not
be visible for scanning and registration by the
NVR. For more information about supported
network devices and models, contact your
retailer.
- Mode: Select the scan mode.
- Advanced Setup: If the camera is networked but
not scanned, use this setup. This setup allows you to
change the network setting of the NVR’s VIDEO IN
port which is camera’s network environment. Check
the camera’s network setting first before you use this
setup. Make sure that this setting does not conflict
with the WAN setting. For more information on the
WAN setting.
1
Select
Scan
to commence scanning.
2
Select a camera from the scan list and then select Add
Camera . The Device Login window will appear.
3
Enter a User ID and a Password for the selected
camera.
Camera View Buttons
● ALIGNMENT Button: Realigns camera screens
displayed on the video display area in the order of Video
In port connections.
● RESET Button: Refreshes the video display area and
the camera list.
● TOOL Button: Displays network camera tool
window to run a camera-related actions. There are
Authentication, Screen Assignment and Camera Protocol
Change for actions.
Camera List Area
Following options can be accessed by right-clicking on a
camera list entry:
● Add/Remove Camera : Adds or removes the selected
camera. The Add Camera option is inactive if the camera
has already been added to the screen.
● Authentication
: Enter the necessary camera login
info. This option is inactive for DirectIP™ / IDIS cameras
because they do not require logins. This option is
inactive for IDIS protocol only if the passoword is set.
Video Display Area
Left-click on the video display area to toggle between split
screen and single screen modes. Drag the camera screens
around to rearrange them. The maximum number of the
channels that can be registered on the NVR and the current
registered camera channels display on the upper left corner
of each screen.