Idis DirectIP DC-T4236HRX, Quick Manual

Page: 6 / 20

6 Quick Guide
1
2
3
4
5
6
RJ45 waterproof rubber ring
RJ45 modular jack
RJ45 connector protect cover
cable waterproof rubber ring
(The waterproof rubber ring is fastened to the connector protect cover.)
RJ45 connector back cover
2
Insert the network cable into the waterproof cap,
rubber bushing, and waterproof cap body in order.
1
2
3
4
5
6
RJ45 waterproof rubber ring
RJ45 modular jack
RJ45 connector protect cover
cable waterproof rubber ring
(The waterproof rubber ring is fastened to the connector protect cover.)
RJ45 connector back cover
3
Plug in the network cable.
1
2
3
4
5
6
RJ45 waterproof rubber ring
RJ45 modular jack
RJ45 connector protect cover
cable waterproof rubber ring
(The waterproof rubber ring is fastened to the connector protect cover.)
RJ45 connector back cover
4
Connect the plug terminal to the RJ45 jack.
1
2
3
4
5
6
RJ45 waterproof rubber ring
RJ45 modular jack
RJ45 connector protect cover
cable waterproof rubber ring
(The waterproof rubber ring is fastened to the connector protect cover.)
RJ45 connector back cover
5
Push the waterproof cap body and cap into the
RJ45 jack and rotate it.
1
2
3
4
5
6
RJ45 waterproof rubber ring
RJ45 modular jack
RJ45 connector protect cover
cable waterproof rubber ring
(The waterproof rubber ring is fastened to the connector protect cover.)
RJ45 connector back cover
6
Lock the waterproof cap into the waterproof cap
body.
Not pulling the cable back may cause water to seep in
and damage the product.
Installation
• Check the wall or ceiling to see if it needs to be
reinforced. The camera may fall off if the wall
or ceiling is not strong enough to support its
weight.
• Install the camera in a shaded area. If the camera
is installed in direct sunlight, it may be affected
adversely.
1
Screw the camera sun shield to the camera using
the screw and rubber provided with the camera.
2
Screw the bottom cover to the wall or ceiling by
using screws(4) and bushings(4) provided with
the camera.
3
Adjust the camera angle by bending the stand.
After fully assembling the joint screws, unscrew it 2
~ 2.5 turns again and move the cover of the joints
of the left 3 places slightly. (The screws should not
be completely released to prevent it from falling.)
After adjusting the direction of the camera, turn
the screw clockwise to secure it completely.