Part 1 - Remote Setup
38
System Event
.
Select
System Event
and configure system event
settings. With system event enabled, system status,
alarm in status, and disk status will be checked
periodically and corresponding alerts will be generated.
•
System Alive
: Select to check the system status and
then set up a schedule.
-
Send Email
: Select to send out an email when the
system comes on line.
-
Remote Callback
: Select this option to send a
message to a remote system when the system
comes on line and then select which system to send
the message to.
•
Alarm In Bad:
Select to check the alarm in status and
then set up a schedule.
-
Send Email
:
Select to send out an email if no
change is detected in the alarm in status.
-
Remote Callback:
Select this option to send a
message to a remote system when the SD memory
card is inserted/removed and then select which
system to send the message to.
•
Disk In/Out
: Select to check if the SD memory card
has been inserted/removed.
-
Send Email
: Select to send out an email when the
SD memory card is inserted/removed.
-
Remote Callback
: Select this option to send a
message to a remote system when the SD memory
card is inserted/removed and then select which
system to send the message to.
•
and
Remote Callback
settings under
Event
Action
must be configured correctly in order to
send out emails and messages.
•
Remote Callback
is not supported on IDIS Web.
• The camera must be registered to the remote
system in order to use the
Remote Callback
feature.
