Part 1 – Introduction
9
DC-D4513WRX
2
1
4
5
6
8
7
!
9
0
1
IR LED
2
Lens
3
Built-in Microphone
4
Factory Reset Button
5
Bottom Cover
6
Network Port
7
SD Memory Card Slot
8
Cable Access Hole
9
Alarm I/O, Audio I/O
0
Wall/Ceiling Installation Hole
!
Cable Rubber
•
IR LED
A sensor inside the system monitors lighting
levels and activates the IR LED during low-lighting
conditions.
•
Lens
Features a fixed focus lens.
•
Built-in Microphone
Receives audio.
DC-D4513RX model only
•
Factory Reset Button
Restores the camera's default factory settings. For
more information, refer to the
.
•
Bottom Cover
Allows you to install the camera on a wall or a ceiling.
•
Network Port
Connect a network cable with an RJ-45 connector to
this port. If using a PoE switch, you can supply power
to the camera using an ethernet cable. For more
information on PoE switch use, refer to the switch
manufacturer's operation manual. You can configure,
manage, and upgrade this camera and monitor its
images from a remote computer over the network.
For more information on network connection setup,
refer to the
IDIS Discovery operation manual
.
The following table describes the network cable
specifications.
<The network cable specifications>
Item
Content
Note
Connector RJ-45
Ethernet
10/100 Base
10/100 Mbps
Cable
UTP Category 5e or
higher
Maximum
length
100m
PoE
IEEE 802.3af, Class 2
•
SD Memory Card Slot
Used to insert a microSD memory card into the
camera. (An SLC (Single Level Cell) or MLC (Multi Level
Cell) card by SanDisk or Transcend is recommended)
•
Do not remove the SD memory card while the
system is in operation. Removing the card while
the system is in operation can cause the system
to malfunction and/or corrupt data stored on the
SD memory card.
•
An SD memory card is a consumable product
with a finite service life. Prolonged use will
damage the card's memory sectors and result
in data loss or memory card failure. Test the SD
memory card regularly and replace it whenever
necessary.
