Part 1 – Introduction
14
Installation
The lens must be purchased separately. If you'd like
to purchase a lens, contact your camera retailer. This
camera supports manual iris lenses and DC type auto iris
lenses in either CS-mount or C-mount format.
• Product color and design may vary depending on
the model.
• We recommend megapixel lenses for clearer and
higher resolution images.
• Video type auto iris lenses are not supported.
• Use a lens that weighs less than 450g. Heavier
lenses can cause the camera to lose its balance.
Check the wall or ceiling to see if it needs to be
reinforced. The camera may fall off if the wall or ceiling
is not strong enough to support its weight.
Manual Iris Lens
1
Remove the protective cover from the camera.
2
Turn the lens in clockwise direction and mount it on
the camera.
3
Rotate the lens' iris ring to open up the iris and then
adjust accordingly.
DC Type Auto Iris Lens
1
Solder on the lens connection line to the connector
socket, if necessary. For more information about
soldering on the lens control wire, refer to the lens
manufacturer's
operation manual
.
1
Connector Socket
Cover
2
Iris Control Cable
3
Connector Socket
4
Heat-Shrinkable
Tube
1
Brake (Damp)
Coil -
2
Brake (Damp)
Coil +
3
Drive Coil +
4
Drive Coil -
2
Remove the protective cover from the camera.
3
Turn the lens in clockwise direction, mount it on to
the camera, and connect the auto iris jack to the
auto iris lens connector.
The auto iris jack must be at least 20cm long in
order to connect it to the camera.