iDirect Evolution 8000 Series, Installation And Safety Manual

Page: 59 / 90

iDirect Evolution 8000 Series Satellite Router Installation and Safety Manual 45
Power Connectors
Port specifications for the iCONNEX e800 Satellite Router are listed in Table 18 .
5.2 Power Connectors
This section describes the details of the iCONNEX e800 Satellite Router power connectors. The
connectors include:
• iCONNEX e800 Satellite Router Remote ON/OFF Switch Connector
• iCONNEX e800 Satellite Router Remote LED Connector
• iCONNEX e800 Satellite Router DC Power Connector
Table 18. e800 iCONNEX Satellite Router Port Specifications
Port Designator Port Name DESCRIPTION
J18 Power
Connector MOLEX P/N 501844-1410 (mates with MOLEX P/N
51353-1400)
J2 10 MHz BNC external 10 MHz connector (future use)
J3 TX Out • F-Connector, female, 3/8”, 32 thread
• 75 ohm nominal
• BUC Voltage: +24V or +48V (depending on input
voltage)
Note: The BUC voltage on the Tx connector is
approximately equal to the input voltage. For
example, if the input voltage is +48V,
approxi48V is present at the TX
connector.
J5 RX Out • F-Connector, female, 3/8”, 32 thread
• 75 ohm nominal
• DC blocked port with terminator
J6 Rx in • F-Connector, female, 3/8”, 32 thread
• 75 ohm nominal
• LNB Voltage: +18.8 VDC nominal at 500 mA maximum
J7 USB Future use
J8 (left) Console RJ-45, serial, RS-232
J8 (right) Lan A RJ-45, 10/100 Base-T
J13 Lan B RJ-45, 10/100 Base-T
J4 RS232/GPIO HD-15, General Purpose Input/Output, serial
JP1 Remote
ON/OFF
Switch MOLEX P/N 89400-0320 (mates with MOLEX part
number 87369-0300)
JP2 Remote LED
Display MOLEX P/N 87831-2020 (mates with MOLEX part
number 87568-2063)